Search:
Submit Search


Progreess on my console

Building organ consoles for use with Hauptwerk, adding MIDI to existing consoles, obtaining parts, ...

Progreess on my console

Postby johnstump_organist » Sun Jan 03, 2010 1:37 pm

Hello all,
http://www.flickr.com/photos/johnstump_ ... 940546863/

These are few pictures of my latest progress. They show my assembled console table, keyboards with finished key-cheeks, pedal-board, Monitor arm and bench all in place. Still need a finished hutch and music stand over the keyboards, a floor in the console, a back on the console. There is space in the cut-out of the knee panel for two more swell pedals (for a Cresc and Positiff, or when I get a theater set they can be Main Solo and Cresc.) The keyboards are a little low right now. I have some 3/4 inch oak stock the I will put a routed edge on and it will go under the bottom key cheek on each side.

John
Last edited by johnstump_organist on Sun Jul 10, 2011 1:37 pm, edited 2 times in total.
User avatar
johnstump_organist
Member
 
Posts: 410
Joined: Wed Mar 25, 2009 2:15 pm
Location: San Miguel de Allende, Guanajuato, Mexico

Re: Progreess on my console

Postby Taco » Thu Jan 21, 2010 1:23 pm

Nice work, please let us see more photographs later when you are finished.
Taco.
User avatar
Taco
Member
 
Posts: 97
Joined: Wed Mar 11, 2009 12:00 pm
Location: Netherlands - Tweede Exloermond.

Re: Progreess on my console

Postby G3 » Fri Jan 22, 2010 10:00 am

Looking Great... I really like the bench. Keep the photos coming.

George (G3)
Owner/Builder of Hammond-Hauptwerks X-66 3-manual organ.
User avatar
G3
Member
 
Posts: 276
Joined: Mon Jul 03, 2006 12:04 pm
Location: Richland Center, WI

Re: Progreess on my console

Postby johnstump_organist » Fri Jan 22, 2010 11:36 am

Thanks,
But work ground to a halt for a while. Wood shop was closed for Holidays, then we had company for a couple of weeks, and there were a few things to attend to that I had ignored while working so intensely on the organ project. But now I purchased and the lumber for the music rack (tulip rosewood, which I hope I can quarter saw and butterfly out into a nice pattern ) and final hutch so I hope to start it next week.
User avatar
johnstump_organist
Member
 
Posts: 410
Joined: Wed Mar 25, 2009 2:15 pm
Location: San Miguel de Allende, Guanajuato, Mexico


Return to DIY organ consoles / MIDI

Who is online

Users browsing this forum: No registered users and 1 guest