Search:
Submit Search


Tuning samples in original pitch

Sampling pipe organs and turning them into something you can play in Hauptwerk.

Tuning samples in original pitch

Postby puciak » Sat Jul 29, 2017 11:37 am

Hello,
Is there possibility to tune samples via ODF while in Original pitch mode? Or is there any easy way to perform that, than editing each file (each sustain file and each release file) separately and perform pitch shift by ear?
puciak
Member
 
Posts: 148
Joined: Sun Jan 29, 2006 7:56 am
Location: Chorzów, Poland

Re: Tuning samples in original pitch

Postby mdyde » Sat Jul 29, 2017 11:56 am

Hello Puciak,

Not within the CODM (which will always use the samples' true pitches for the output pitch when the user selects 'original organ tuning'). In the full ODF format it's possible to specify an output pitch for each pipe that can be different from its sample's pitch using the following two attributes:

- Pipe_SoundEngine01.Pitch_OriginalOrgan_SpecificationMethodCode,
- Pipe_SoundEngine01.Pitch_OriginalOrgan_PitchHz.
Best regards,
Martin.

[Please use email or the Contact page if you need to contact us privately, rather than private forum messages.]

Image
User avatar
mdyde
Moderator
 
Posts: 10175
Joined: Fri Mar 14, 2003 2:19 pm
Location: UK

Re: Tuning samples in original pitch

Postby puciak » Sat Jul 29, 2017 1:35 pm

Thank you for response. So in Sample table I should set Pitch_SpecificationMethodCode=4, Pitch_ExactSamplePitch=(here write true pitch detected from sample) and in Pipe_SoundEngine01 set Pitch_OriginalOrgan_SpecificationMethodCode=1 and Pitch_OriginalOrgan_PitchHz=(calculated, desired pitch)?
And what about changing temperaments then, Hauptwerk will use only pitch information supplied in Sample table?
puciak
Member
 
Posts: 148
Joined: Sun Jan 29, 2006 7:56 am
Location: Chorzów, Poland

Re: Tuning samples in original pitch

Postby mdyde » Sat Jul 29, 2017 2:11 pm

Hello Puciak,

puciak wrote:So in Sample table I should set Pitch_SpecificationMethodCode=4, Pitch_ExactSamplePitch=(here write true pitch detected from sample)


That would be valid, although you could also use Pitch_SpecificationMethodCode=1 ('Read precise pitch from sampler chunk in sample file') if the pitch is stored in the sample. The important thing is that they specify the true pitch of the sample.

puciak wrote:Pipe_SoundEngine01 set Pitch_OriginalOrgan_SpecificationMethodCode=1 and Pitch_OriginalOrgan_PitchHz=(calculated, desired pitch)


Correct.

puciak wrote:And what about changing temperaments then, Hauptwerk will use only pitch information supplied in Sample table?


Correct. The Pitch_OriginalOrgan_... attributes are only used when the user selects 'original organ tuning' instead of a temperament.
Best regards,
Martin.

[Please use email or the Contact page if you need to contact us privately, rather than private forum messages.]

Image
User avatar
mdyde
Moderator
 
Posts: 10175
Joined: Fri Mar 14, 2003 2:19 pm
Location: UK


Return to Creating sample sets / recording organs

Who is online

Users browsing this forum: No registered users and 1 guest