Can someone please explain, or point to an explanation of, the wet mix % parameter's intended effect. This is set on the Audio Mixer window where you add impulse reverb to a bus. I can't seem to find a definition in the user guide, forum, or HW 5 info help.
This might be a related question or not: I set up intermediate buses as aux reverb mixes for each primary bus so I can direct reverb to a different stereo channel from each source channel. That works as expected -- very well. I picked St Max (church 09) to test drive it on semi-dry organs.
But when I loaded a surround organ and set the per-organ wetness slider to 0 to disable reverb processing, it sounds like the source signal is still being sent at a fairly high level by the intermediate buses, which isn't desirable since it messes up the surround channel locality and increases volume by at noticeable amount.
So, is it possible (with a single mixer preset), to get reverb added for some organs and turn off all the extra sound from the aux reverb mixes for other organs by setting the wetness slider to 0? Or will it always include some of the source (dry but not) sound?
The church 09 IR's wet mix % defaults to 37%. Would 100% remove the source/dry sound and make it all reverb?
Thank you.
This might be a related question or not: I set up intermediate buses as aux reverb mixes for each primary bus so I can direct reverb to a different stereo channel from each source channel. That works as expected -- very well. I picked St Max (church 09) to test drive it on semi-dry organs.
But when I loaded a surround organ and set the per-organ wetness slider to 0 to disable reverb processing, it sounds like the source signal is still being sent at a fairly high level by the intermediate buses, which isn't desirable since it messes up the surround channel locality and increases volume by at noticeable amount.
So, is it possible (with a single mixer preset), to get reverb added for some organs and turn off all the extra sound from the aux reverb mixes for other organs by setting the wetness slider to 0? Or will it always include some of the source (dry but not) sound?
The church 09 IR's wet mix % defaults to 37%. Would 100% remove the source/dry sound and make it all reverb?
Thank you.