Hello damuehlbauer,
Please try:
- Load the St. Anne's organ.
- On the '
General settings | General preferences | Advanced ...' screen tab, turn on the '
Diagnostics: log all MIDI messages received ...' option. OK the screen.
- Wait 10 seconds or so (without touching anything, so that I'll be able to tell the relevant MIDI messages apart easily in the log).
- (Being careful not to touch anything else, for the same reason), right-click on the Open Diapason Large 8 stop on the virtual console screen and select '
Auto-detect ...'.
- (Being careful not to touch anything else), press down on your MIDI sustain pedal switch.
- Wait 10 seconds or so (without touching anything).
- (Being careful not to touch anything else), stop pressing your MIDI sustain pedal switch. If auto-detection has been successful then the Done button should become enabled. Click it, if so (making sure that the '
Toggle state ...' option is not ticked). If the Done button hasn't become enabled, then click Cancel instead.
- (Without touching anything else), use '
Help | Create a diagnostic file' and send the resulting file to us:
http://www.hauptwerk.com/forms/support/ .
- Turn MIDI logging off again on the general preferences screen.
That will allow me to see exactly what MIDI messages your MIDI sustain pedal switch is transmitting, and hopefully thus give a clue as to what the problem might be. Thanks.
Best regards, Martin.
Hauptwerk software designer/developer, Milan Digital Audio.