It is currently Thu Jun 17, 2021 11:51 am


Non-coupling solo reed

Using the CODM to create your own organ definitions, exchange CODM organ definitions, ...
  • Author
  • Message
Offline

PCF

Member

  • Posts: 34
  • Joined: Wed Nov 27, 2019 7:44 am

Non-coupling solo reed

PostMon Mar 30, 2020 3:09 am

Good day,

I would like to duplex a (loud) solo reed (e.g., from a Solo division) to another division(s) (e.g., SW and/or GT), and then make that duplexed reed stop non-coupling in those (GT and/or SW) divisions (i.e., not affected by intra- and intermanual couplers).

How would I go about in doing that using the CODM?

Thank you for any advice.
Offline
User avatar

mdyde

Moderator

  • Posts: 13376
  • Joined: Fri Mar 14, 2003 1:19 pm
  • Location: UK

Re: Non-coupling solo reed

PostMon Mar 30, 2020 5:50 am

Hello PCF,

You would do it by putting it on a separate Division object, and setting up couplers as desired (using Coupler.CouplerCodeFromWhichToCopyState when applicable), similar to the way the 'Swell Reeds on Choir' coupler is implemented in ExampleCustomOrgan2. The 'stops' that control it (on either of the two real divisions) would actually instead be implemented as couplers.
Best regards, Martin.
Hauptwerk software designer/developer, Milan Digital Audio.
Offline

PCF

Member

  • Posts: 34
  • Joined: Wed Nov 27, 2019 7:44 am

Re: Non-coupling solo reed

PostTue Mar 31, 2020 11:21 am

Thank you so much Martin.
Offline
User avatar

mdyde

Moderator

  • Posts: 13376
  • Joined: Fri Mar 14, 2003 1:19 pm
  • Location: UK

Re: Non-coupling solo reed

PostWed Apr 01, 2020 3:21 am

Thanks, PCF.

You're very welcome.
Best regards, Martin.
Hauptwerk software designer/developer, Milan Digital Audio.

Return to Custom Organ Design Module (CODM)

Who is online

Users browsing this forum: No registered users and 1 guest