Re: Large Church Installation - Open Conversation, Please
Posted: Thu Mar 10, 2016 10:57 am
I will focus more on the console later.
For now, I am focused on the audio system. This is, after all, the "Amplification" section.
Danny B. has intrigued me with this comment. I'm wondering what the results would be if I basically split each of these TLAH arrays in half - but still in the same housing. In other words, what would happen if I used one TLAH Pro, but the four upper drivers and piezos were essentially one channel, and the bottom four were another audio channel.
I'm thinking that if it's divided this way, maybe route certain pitches (Say, all C's and G's) to the full TLAH, but the top half handles a certain number of ranks (say, all principals), and the bottom half handles a different number of ranks (say, reeds)? Then, on they opposite speaker, you'd have the sharps of those notes - on a completely different TLAH, but configured the same way. Maybe this illustration will clarify....
Yes, it will change the impedance, but that's no big deal. Thoughts?
For now, I am focused on the audio system. This is, after all, the "Amplification" section.
magnaton wrote:Regarding speakers, you will be given lots advise and opinions here. I'm not familiar how a line array will sound with HW. Since you are almost finished with the TALH Pros you'll soon be finding out. Is one speaker array with the 16 drivers just one channel? If so, I would consider building several of these or better yet make them 1/2 sizes (8 drivers) if that is feasible so you can have more channels.
~Danny B.
Danny B. has intrigued me with this comment. I'm wondering what the results would be if I basically split each of these TLAH arrays in half - but still in the same housing. In other words, what would happen if I used one TLAH Pro, but the four upper drivers and piezos were essentially one channel, and the bottom four were another audio channel.
I'm thinking that if it's divided this way, maybe route certain pitches (Say, all C's and G's) to the full TLAH, but the top half handles a certain number of ranks (say, all principals), and the bottom half handles a different number of ranks (say, reeds)? Then, on they opposite speaker, you'd have the sharps of those notes - on a completely different TLAH, but configured the same way. Maybe this illustration will clarify....
Yes, it will change the impedance, but that's no big deal. Thoughts?