(Briefly, since we don't officially provide support for the 'full' organ definition format, as covered before -- the Custom Organ Design Module is intended to be used instead:)
puciak wrote:I would like to create switch, which will work as multiple OR gate. For example I want to know if any key on first division is pressed. I got division input switches. As I read in the manual, switches in non-latching mode has some counting abilities and I guess it works in handreg/combination/crescendo system, but I'm not sure how.
The simplest way would be to make a momentary (non-latching) node Switch, and then create SwitchLinkages with standard actions from all of your division input switches to it. Then the node switch will be on whenever any one of the 'source' switches is on.
puciak wrote:And short second question: how to make stop knobs controlling the same stops on two display pages? Which switch should be selected as stop control? I tried to make 2 simple switch linkages between the switches (from one to another and vice versa, with no condition), but it works strange.
You should just need to have a separate *latching* switch for the stop on each of the two pages, with a standard SwitchLinkage from the first to the second, and another standard SwitchLinkage from the second to the first. Since the switches are latching no infinite recursion will occur. It doesn't matter which of the two switches is designated as the (primary) stop/input-output switch.