Page 1 of 1

New hall effect keyboard's conntact

PostPosted: Tue Jun 18, 2019 1:50 am
by thomas690
New hall effect keyboard's contact set, allow you to convert any keyboard into MIDI keyboard. This system was basically developed for MGB encoders but any other if is working in the same standard is OK. Extreme small profile allow it to use in almost any situation. Even if point on the surface key where sensor should be located has movement about 2mm, it allow to construct good, precise keyboard. Important is that firing point could be easy regulated by small trim pots. This "on" position could appear very close to the resting position of the key. It make whole system more comparable to natural organ keyboard. Whole set is sold with PS 6V and suitable screwdriver for regulation pots. Ready to fix on keyboard. Doesn't need any soldering, or other precise electrical job. Please visit http://www.pipeorganlogic.com

Re: New hall effect keyboard's conntact

PostPosted: Tue Jun 18, 2019 7:35 pm
by scottherbert
What is the price?

Re: New hall effect keyboard's conntact

PostPosted: Tue Jun 18, 2019 11:02 pm
by thomas690
Hi,
Price for one keyboard is $220 (USD) + shipping cost.
Before ordering, contact me (info@pipeorganlogic.com) to match your conditions. Length of cables, positioning of magnets. in some cases magnets have to be install on additional spacers or direct on metal surface if it is metal keyboard. This elements have to be prepared for individual needs for minimize job at customer place.
Regards