Hello vpo-organist,
vpo-organist wrote:mdyde wrote:In that situation, why not simply use one of the four Hauptwerk configurations (desktop short-cuts) -- which all have completely independent settings -- for your home environment, and another for the church?
Because this is much too cumbersome and requires additional disk space for the Hauptwerk-Cache.
Just to clarify -- I was actually replying there to Iain's questions (about having separate settings for absolutely everything), not to your questions about having just separate voicing/routing/mixer settings.
vpo-organist wrote:Dear Martin, I am currently working on the acoustic parameters for an IR.
I noticed that the wet slider from the audio mixer popup is missing when testing the settings.
If this slider would be integrated into the dialog, then I would have all parameters and setting possibilities
in one place and can configure the acoustics comfortably.
Could you clarify what you mean by the 'audio mixer popup'? E.g. are you referring to the '
General settings | Audio mixer' screen?
By 'wet slider', are you referring to the '
Mixer ... reverb wetness scalar %' slider that's on the
Audio Mixer, Routing and Voicing/Panning' settings large control panel (
View | Large floating control panels ...')?
If so, that control panel slider intentionally isn't duplicated on the mixer screen, since it's an *overall* wetness control, whereas the controls on the mixer screen apply only to the selected mixer bus. Like all of Hauptwerk's settings screens, the controls in the right-hand pane relate solely to the item that's selected in the item list in the left-hand pane -- that's intentional, to avoid any ambiguity. Also, I don't think we'd want to make the mixer screen larger than it needs to be by duplicating controls on it that can be found on other screens. If you want to keep access to the wetness slider while you're adjusting things on the mixer screen, the it's intended that you should keep both screens (mixer, plus the control panel) open at the same time.
However, there is a *per-mixer-bus* '
Wet mix %' control in the right-hand pane on the mixer. (The value settings on the mixer don't currently have graphical sliders/knobs, but we do hope to add some in the longer term, to make it quicker to adjust the values than typing them or using the up/down buttons.)
Best regards, Martin.
Hauptwerk software designer/developer, Milan Digital Audio.