Sat Apr 16, 2022 3:49 am
Hello Dan,
I'm not sure that I'm quite clear what you're describing, but please try:
1. Launch Hauptwerk (without loading an organ, to help avoid any potential for confusion).
2. On Hauptwerk's menu, make sure all three of the "View | Console window 2-4" options are unticked, so that only the main Hauptwerk window remains visible.
3. Drag the main window onto your primary computer monitor.
4. Now tick "View | Console window 2" on the menu. Console window 2 will open. It will normally remember it's previous position, but if that was invalid then it may open on top of the main Hauptwerk window. (If you still can't see it, check whether it's opened behind the primary window, by dragging the primary window a little to one side.) Drag that console window 2 onto your second computer monitor. You should now have the main console window on your primary computer monitor, and console window 2 on your second computer monitor.
5. Now load the St. Anne's organ (as a test).
6. In the main Hauptwerk window (which you positioned on your primary computer monitor), click on (for example) the "Left jamb" tab above the graphical console, so that the graphical St. Anne's left jamb display is shown on your primary computer monitor.
7. Likewise, in console window 2 (which you positioned on your second computer monitor), click on (for example) the "Right jamb" tab above the graphical console, so that the graphical St. Anne's right jamb display is shown on your primary computer monitor.
8. Exit Hauptwerk.
9. Re-launch it, and re-load St. Anne's. You should see that its left jamb still shows on your primary computer monitor, and its right jamb on your second computer monitor.
Does that work properly for you? If not, at which of the above stages do you have a problem, and what happens instead?
[Edit: P.S. I see that Iain and I replied at the same time. Thanks, as always, Iain.]
Best regards, Martin.
Hauptwerk software designer/developer, Milan Digital Audio.