Hello Scott,
First, for good measure, go to the "
General settings | Audio device and channels" screen and check that the device channel numbers are still mapped in their default way, i.e. channel 1 -> device channel 1, 2->2, 3->3, 4->4, 5->5, etc.
I assume by 'Router' you mean your audio interface's control panel software, so that your device channels are as follows:
- Device channels 1+2: Great/Swell stereo speaker pair 1.
- Device channels 3+4: Great/Swell stereo speaker pair 2.
- Device channels 5+6: Choir/Solo stereo speaker pair 1.
- Device channels 7+8: Choir/Solo stereo speaker pair 1.
- Device channels 9+10: Subwoofer (stereo).
- Device channels 11+12: Headphones (stereo).
You could set things up as follows, for example:
- On the "
General settings | Audio mixer" screen:
------ Master mix bus 3 (sub-woofer):
-----------
Audio output device channels: Channels = Stereo: 9+10.
------ Master mix bus 2 (headphones):
-----------
Audio output device channels: Channels = Stereo: 11+12.
------ Primary bus 20:
-----------
Name = "Great/Swell stereo speaker pair 1".
-----------
Audio output device channels: Channels = Stereo: 1+2.
------ Primary bus 21:
-----------
Name = "Great/Swell stereo speaker pair 2".
-----------
Audio output device channels: Channels = Stereo: 3+4.
------ Primary bus 30:
-----------
Name = "Choir/Solo stereo speaker pair 1".
-----------
Audio output device channels: Channels = Stereo: 5+6.
------ Primary bus 31:
-----------
Name = "Choir/Solo stereo speaker pair 2".
-----------
Audio output device channels: Channels = Stereo: 7+8.
- On the "
General settings | Audio mixer bus groups" screen:
------ Group 20:
-----------
Name = "Great/Swell".
----------- Buses ticked (and no others): 20, 21.
------ Group 30:
-----------
Name = "Choir/Solo".
----------- Buses ticked (and no others): 30, 31.
- Now load St. Anne's, and go to the "
Organ settings | Rank routing ..." screen and route the ranks as follows:
------ All Great ranks, and all Pedal ranks:
-----------
Rank output perspective 1: Destination mixer bus group[ = 20 ("Great/Swell").
------ All Swell ranks (for example, since St. Anne's doesn't have a Choir or Solo):
-----------
Rank output perspective 1: Destination mixer bus group[ = 30 ("Choir/Solo").
Does that solve it?
SKresge wrote:I noticed in both HW and in the Router application that Channel 9 is lighting up for every keystroke on all manuals and it is not selected in the Audio Mixer Bus Groups Screen, only two boxes are ticked for each division like it is intended, how is 9 lighting up and nothing is coming out of the subwoofer?
Yes -- that would be normal and expected, assuming that you currently have your device channels 9+10 selected for one the 'master mix' buses on Hauptwerk's Audio Mixer (as opposed to having either of those device channels selected for any of the primary buses), because all primary buses mix down to the master mix buses by default:
mdyde wrote:(The reason that you would hear primary buses through your headphones even if no speaker channels were selected for them directly, is that all buses mix down [via their "Sends: to master mix buses"] to the master mix buses by default, specifically so that you can always hear everything through headphones, and not just certain ranks.)
Best regards, Martin.
Hauptwerk software designer/developer, Milan Digital Audio.