4 wire swell potentiometer?

Building organ consoles for use with Hauptwerk, adding MIDI to existing consoles, obtaining parts, ...
Post Reply
User avatar
ajt
Member
Posts: 870
Joined: Sun Nov 12, 2006 6:40 pm

4 wire swell potentiometer?

Post by ajt »

I've recently acquired an old Miller "Norwich" console. It's very well made, but very old.

The swell pedal is confusing me - it appears to have 4 wires going to it in 2 pairs.

Pair 1 - this went to what appears to be a combined amplifier and power source so I'm assuming is power:
White insulated wire x 2

Pair 2 (in grey insulation):
Blue insulated wire
"Bare wire"

I'm assuming one pair is positive and ground and the other is "signal" and ground.

If I wire up Pair 1 as +/- and Pair 2 as Signal/Ground, I get 0 signal. If I remove the ground from either pair, then I get signal but nothing that relates to the movement of the pedal.

Same if I flip Pair 1 to be Signal/Ground and Pair 2 to be +/-.

So I'm clearly wrong. Any ideas?

Image:
https://photos.app.goo.gl/XasK5C7ns5aAQjNDA
Adrian
rayjcar
Member
Posts: 123
Joined: Mon Mar 17, 2014 9:56 am

Re: 4 wire swell potentiometer?

Post by rayjcar »

I did a bit of searching, and it appears that the potentiometer is actually an LDR (light dependent resistor).

https://www.vintage-radio.net/forum/attachment.php?s=5db715d4820f7a3db7bc702aac7fb812&attachmentid=275474&d=1679402762

If you look at the top left corner of the attachment, two wires supply voltage to the lamps, and the other two provide the resistance value. There is a mechanical shutter which varies the amount of light.
So without the lamps powered, you won't read any resistance. Even if you do, you may not have the value and taper required for a typical midi encoder (i.e. 5k to 10k resistance, linear taper. Your best bet would be to replace the potentiomenter with a new one with correct shaft size and rotational arc that matches the existing rotation.

Ray
User avatar
ajt
Member
Posts: 870
Joined: Sun Nov 12, 2006 6:40 pm

Re: 4 wire swell potentiometer?

Post by ajt »

Wow, your internet searching skills are better than mine - really useful, thank you!
Adrian
larason2
Member
Posts: 810
Joined: Thu Feb 04, 2016 9:32 pm

Re: 4 wire swell potentiometer?

Post by larason2 »

I agree with Ray, trying to get a light dependent resistor to work with an arduino is a headache. You could also try a linear pot with an inexpensive plastic mount.
Coenraads
Member
Posts: 73
Joined: Fri Feb 01, 2019 10:13 pm

Re: 4 wire swell potentiometer?

Post by Coenraads »

When MIDifying a Galanti some years ago, I retained the LDR based swell pedal by adding a pullup resistor as shown in the bottom picture:

https://sites.google.com/site/casavantopus400/pictures

But the resulting small voltage range (Voltage readings 2.06 volts (closed) to 3.79 (open) ) required code different from that used with a potentiometer. In my parallel scanner program:

https://sites.google.com/site/casavanto ... el-scanner

I therefore provide two different methods of scanning the expression pedal. (Method 2, for LDRs is commented out but is there if needed). This method worked just fine with the Galanti.
Post Reply