No sound unless switching mixer presets

Hauptwerk software technical support only. Please make sure you have read the manual, tutorials and FAQ pages before requesting support.
Post Reply
DavidHicken
Member
Posts: 2
Joined: Wed Dec 29, 2021 12:38 am

No sound unless switching mixer presets

Post by DavidHicken »

I have just started to experience some strange behaviour with Hauptwerk 8. When I load an organ, I only get sound from outputs 1& 2 of my interface, but when I switch to mixer preset 2 and then back again to mixer preset 1, everything is fine and I get multi output as normal. This has only just started happening and I always have to switch to mixer 2 and then back to 1. Any ideas?
User avatar
mdyde
Moderator
Posts: 15695
Joined: Fri Mar 14, 2003 1:19 pm

Re: No sound unless switching mixer presets

Post by mdyde »

Hello David,

There is a small bug in Hauptwerk v8.0.0/v8.0.1 which can give that problem, but there is an easy work-around:

https://www.forum.hauptwerk.com/viewtop ... 50#p157750
mdyde wrote:in Hauptwerk v8.0.1 or v8.0.0 if you're routing directly to a primary bus (not via a group) then please make sure that your primary bus is also in at least one group (e.g. use a group such as 1024 as 'dummy' group to put it in -- no need actually to route any ranks to the group): https://www.forum.hauptwerk.com/viewtop ... 22#p157122
My apologies for that bug.
Best regards, Martin.
Hauptwerk software designer/developer, Milan Digital Audio.
DavidHicken
Member
Posts: 2
Joined: Wed Dec 29, 2021 12:38 am

Re: No sound unless switching mixer presets

Post by DavidHicken »

Thanks a lot for your reply. I’ll make sure to do as you suggest.
User avatar
mdyde
Moderator
Posts: 15695
Joined: Fri Mar 14, 2003 1:19 pm

Re: No sound unless switching mixer presets

Post by mdyde »

Thanks, David.
Best regards, Martin.
Hauptwerk software designer/developer, Milan Digital Audio.
Post Reply