More than one audio interface...

Connecting Hauptwerk to MIDI organs, sequencers, ...
Post Reply
sclg
Member
Posts: 120
Joined: Wed Jul 08, 2009 3:22 pm

More than one audio interface...

Post by sclg »

Is it possible with HW8 to run two ASIO audio interface units?
Currently I use all my 8 channels for speakers but it would be nice to have the headphone option.
My current 8 channel unit doesn't have a headphone output, but I do have another, older, Focusrite unit around....

Thanks
mnailor
Member
Posts: 1721
Joined: Sat Nov 30, 2013 5:57 pm

Re: More than one audio interface...

Post by mnailor »

HW can only address one audio interface on Windows. I use ADAT to forward audio channels from the audio interface HW sees to the second one. AVB would also allow that.
User avatar
mdyde
Moderator
Posts: 15695
Joined: Fri Mar 14, 2003 1:19 pm

Re: More than one audio interface...

Post by mdyde »

Hello Steve,

To add to Mark's reply:

The ASIO architecture only allows a single ASIO driver to be used at a time. However, a few manufacturers have ASIO drivers which allow multiple units of the same make (and maybe also of the same model) to be used at once. (E.g. if I recall correctly at least some RME interfaces support that.) Hence if you have such a model, you might possibly be able to buy another identical one (or compatible one of the same make) and use it together with the original. Check with its manufacturer if in doubt. If it turns out that you can use two or more of them, it would usually be very important to ensure that their clocks are synchronised together (e.g. with Word Clock cables).

Instead expanding via ADAT and/or AVB may be an option if you existing interface has ports for either of those, as Mark mentioned.
Best regards, Martin.
Hauptwerk software designer/developer, Milan Digital Audio.
sclg
Member
Posts: 120
Joined: Wed Jul 08, 2009 3:22 pm

Re: More than one audio interface...

Post by sclg »

Thanks both.
Back to the drawing board then!
Steve
User avatar
magnaton
Member
Posts: 699
Joined: Tue Feb 10, 2015 6:28 pm

Re: More than one audio interface...

Post by magnaton »

I've never tried this, but couldn't you assign the headphones to the native Windows audio stereo driver? Could these work independently? If so, you would use your computer's 1/8" stereo jack for the headphone feed.

Danny B..
User avatar
mdyde
Moderator
Posts: 15695
Joined: Fri Mar 14, 2003 1:19 pm

Re: More than one audio interface...

Post by mdyde »

Hello Danny,

No -- you can only use one audio driver at a time in Hauptwerk, I'm afraid (to ensure synchronisation).
Best regards, Martin.
Hauptwerk software designer/developer, Milan Digital Audio.
Post Reply